If customer wishes to supply own fabric (COM: customer’s own materials), please call for yardage requirements. If customer supplies own fabric, there is an additional 15% charge.

 

Fabric Requirements
Yardage requirements shown are based on 54” Plain Goods. If fabric is less than 54” or has repeat of more than 2”, please refer to the chart below.
Fabric Width
Plain
2“ - 14”
15” - 19”
Repeat
20” - 27”
Repeat
28” - 36”
Repeat
37” - 45”
Repeat
46” - 54”
Repeat
54”
0
10%
15%
20%
25%
30%
35%
52”
10%
20%
25%
30%
35%
40%
45%
50”
10%
20%
25%
30%
35%
40%
45%
48”
15%
25%
30%
35%
40%
45%
50%
45”
20%
30%
35%
40%
45%
50%
55%
35”
50%
60%
65%
70%
75%
80%
85%

* Please note: All fabric patterns are cut to match vertically and horizontally. Add allowance for pattern repeat.
** The above chart is an estimate only. Greenbriar Designs is not responsible if additional yardage is required.
*** No silk will be accepted by Greenbriar Designs for upholstery.



Railroading:


The term ‘Railroading’ refers to the way the fabric is laid out on the furniture in relation to the way it is manufactured. Patterns that run “up the roll” are non-railroaded, which is considered the standard application. The design, if any, runs from salvage to salvage.

If the design runs horizontally from one end of the roll to the other, the design might appear to be “on its side." This fabric is considered railroaded and yardage requirements could vary from the chart above. Please contact Greenbriar Designs for assistance on railroaded fabrics.

Cutting instructions must be specified for each order. Please do not assume that the fabric application is obvious. It must be stated as “Railroaded” or “Up the Roll." In the absence of specific instructions, Greenbriar Designs will not be held responsible for COM applications deemed unsatisfactory by the customer.